bass cut control sending hot signal to ground

[jbhaugh]

Hello,

I've wired up my 1k with new pots and a new pickup (i had a dead coil in the original pickup), and now no signal is passing to the output. I checked continuity and I'm getting continuity everywhere up until I check the connection from the bass cut pot back to the volume pot, and I have no output, not even a hum.

The wiring looks correct according to the diagrams here and all component values are to spec.

[Ken Baker]

It's possible that visual fatigue might be setting in when you're comparing your bass to a drawing. Perhaps have someone else help?

Click the image for a PDF version.



Ken...